Domestic Pumps
Peripheral Electric
Light Duty Monobloc
Centrifugal Contra Impellers
Light Duty Multistage
Self Priming Jet c/w Ejector
Self Priming Jet AISI 316
Closed Coupled Monobloc
Electric Gear Pump
Swimming Pool Filtered
Pressurisation Sets c/w Jet
Phone: 01293 533 665
Email: enquiries@thepumpco.co.uk
 
This series of electric single impeller close coupled centrifugal pumps is fitted with the overhang impeller directly splined / keyway on the motor shaft. The liquid pumped is conveyed into the spiral shaped volute of the pump body, transforming the kinetic energy into dynamic pressure energy.
Pressure and flow is achieved with minimum loss by means of the hydrodynamic closed impeller design.
Single phase motors with a built in thermal overload protection on request, the capacitor is permanently in circuit
Motor protection to IP44 (available in IP55 upon request).
Winding insulation to class F
Standard voltage: 230V- 50Hz single phase, 230V/400V- 50Hz three phase.
Other voltages and frequencies available upon request
Industrial water supply, pressurized water using pressure vessels (autoclaves), various horticultural and agricultural irrigation applications, civil and domestic water transfer schemes.
The open impeller design allows the pump to handle slightly dirty water.
Capacities up to 120 m3/hr
Heads up to 24 meters
Liquid quality required clean or slightly dirty water, chemically non aggressive.
Maximum Temperature of pumped liquid -15°C to +70°C
Maximum ambient temperature 40°C. For higher temperatures please contact the sales office.
Maximum working pressure 6 bar.
The tolerances of the hydraulic features are according to UNI / ISO 2548-Class C, Appendix B, electric features according to C.E.I.
The working features listed in the catalogue are based on continuous service for clear water with a specific weight of 1000 kg/m3.
Manometric suction lift of 8 meters with a foot valve, for a suction lift of above 5 meters it is advisable to install the suction pipe with a internal diameter larger than the pump inlet.
Pump body and motor support in cast iron.
Impeller pressed brass on BP 3- 4 - 5 - 6.
Impeller cast iron on CMK - BP 7 - 8.
Mechanical seal in graphite/ceramic.
Rotor shaft fitted with seal for life bearings.
Totally enclosed fan cooled motor (TEFC).
       
The Pump Company Limited, 22 The Bell Centre, Newton Road, Crawley, West Sussex, RH10 9FZ
Tel: (0)1293 533665. Fax: (0)1293 533664 Registered in UK 3428736