Domestic Pumps
Peripheral Electric
Light Duty Monobloc
Centrifugal Contra Impellers
Light Duty Multistage
Self Priming Jet c/w Ejector
Self Priming Jet AISI 316
Closed Coupled Monobloc
Electric Gear Pump
Swimming Pool Filtered
Pressurisation Sets c/w Jet
Phone: 01293 533 665
Email: enquiries@thepumpco.co.uk
 
The series of electric KF pumps has a peripheral type impeller.
These pumps are made in this way because on the extremities of the impeller there are several radial paddles which give more energy to the pumped liquid.
The special shaping of the paddles gives the fluid a fast radial recycling motion between the paddles of the impeller and the pump body.
This characteristic enables the fluid to increase progressively the pressure during its way from the inlet to the outlet, obtaining a regular and not pulsating flow and high pressures with quite slopping curves.
Single phase motors with a built in thermal overload protection on request, the capacitor is permanently in circuit
Motor protection to IP44
Winding insulation to class B (for motors of size 63), F (for other sizes)
Standard voltage: 230V- 50Hz single phase, 230V/400V- 50Hz three phase.
Other voltages and frequencies available upon request
General water supply, pressurized water using pressure vessels (autoclaves), horticultural irrigation, mist irrigation, boosting showers, dairy and farm applications, garden watering applications, to empty and fill cisterns for clean liquids only.
Capacities up to 4.2 m3 / hr
Heads up to 88 meters
Liquid quality requirement is clean and free from solids or abrasive substances and non aggressive
Maximum temperature of pumped liquid - 15°C to +70°C
Maximum ambient temperature 40°C.
For higher temperatures please contact the sales office.
Maximum working pressure 9 bar.
The tolerances of the hydraulic features are according to UNI / ISO 2548-Class C Appendix B electric features according to C.E.I.
The working features listed in the catalogue are based on continuos service for clear water with a specific weight of 1000 kg/m3.
Manometric suction lift of 8 meters with a foot valve fitted, for a suction lift of above 5 meters it is advisable to install the suction pipe with a internal diameter larger than the pump inlet.
Pump body and motor support in cast iron, pressed brass impeller.
Mechanical seal in carbon/ceramic, rotor shaft in stainless steel with seal for life bearings.
Totally enclosed fan cooled motor (TEFC).
       
The Pump Company Limited, 22 The Bell Centre, Newton Road, Crawley, West Sussex, RH10 9FZ
Tel: (0)1293 533665. Fax: (0)1293 533664 Registered in UK 3428736