Industrial Pumps
Positive Displacement
Self Priming Centrifugal
J Series Varisco
Thermoplastic Argal
Side Channel Robuschi
Electric SAER
Engine SAER
End Suction Centrifugal
In-line Pumps
Dosing Pumps
Air Operated Pumps
Phone: 01293 533 665
A Self priming pump recirculates the liquid in the pump casing to remove air from the suction line, enabling the pump to draw liquid through the suction line.
The Saer AP97, there is a non return valve fitted into the discharge side which retains liquid in the casing when the pump is stopped, this means it is always ready to pump immediately when restarted.
The SAER AP97 is a pump suitable for general water supply from rivers, streams, dirty water distribution, agricultural applications, building sites, dirty water disposal.
The open impeller design allows water with a solid content to pass easily, whether sandy, muddy or particle laden.
Self Priming capabilities
Can come complete with an easy to carry handle
Totally enclosed fan cooled motor (TEFC)
Single phase motors with a built in thermal overload protection on request, the capacitor is permanently in circuit
Motor protection to IP44 (available in IP55 upon request)
Winding Insulation to class F
Standard Voltage: 230V-50Hz single phase, 230V/400V-50Hz three phase
Other voltages and frequencies available upon request
Water Handling
Capacities up to 30 m3/hr
Heads up to 16,5 meters
Maximum Temperature of pumped liquid -15°C to 70°C
Maximum ambient temperature 40°C
For higher temperatures please contact the sales office
Maximum working pressure 6 bar
Manometric suction lift of 8 meters maximum
Pump body, impeller, pump support and inlet in cast iron
Non return valve in nitrile rubber and steel
Impeller cast iron
Mechanical seal in carbon ceramic (upon request tungsten/carbide)
Rotor shaft in stainless steel fitted with seal bearings
The Pump Company Limited, 22 The Bell Centre, Newton Road, Crawley, West Sussex, RH10 9FZ
Tel: (0)1293 533665. Fax: (0)1293 533664 Registered in UK 3428736